Call Toll Free: 1-888-353-2649|info@ecologyworks.com
Vital Oxide Instructions For Use 2015-12-15T19:25:41+00:00

Vital Oxide Directions for Use: – Always refer to the product label for full instructions

Storage Instructions: Store in original container in a cool, dry place away from heat and open flame. Product temperature cannot exceed 100o

  • To Clean and Disinfect Hard Non-Porous Surfaces: Full Strength

    • Pre-clean surface with warm soapy water, rinse and allow to dry.
    • Apply Vital Oxide full strength, enough to thoroughly wet surface.
    • Allow surface to remain wet for 5 minutes for viral inactivation – 10 minutes for bacterial disinfection.
    • For immersion applications, replace solution daily, or more frequently if it becomes significantly soiled or diluted.
    • No rinsing required, just air dry.
  • To Clean and Disinfect Floors: 5:1 Dilution

    • Sweep or vacuum floor to remove particles.
    • Mop the floor with warm, soapy water to remove any dirt or stains, rinsing the mop with clean water frequently.
    • Apply Vital Oxide at a dilution of 5 parts water to 1 part Vital Oxide.
    • No rinsing required, just air dry.
    • Do NOT use Vital Oxide on non-sealed wood floors.
  • To Pre-Treat and Sanitize Synthetic Carpets: 5:1 Dilution

    • Vital Oxide can be used to treat synthetic carpet fibers, like nylon, olefin or polypropylene. Do NOT use Vital Oxide on wool carpets.
    • First, prepare carpet by cleaning or vacuuming up excessive dirt.
    • If carpet holds any chemicals from previously used products, be sure to clean carpet before applying Vital Oxide.
    • To Pre-treat carpet stains – apply Vital Oxide at a dilution of 5 parts water to 1 part Vital Oxide.
  • To Sanitize carpets: 5:1

    • First, test for color fastness in an inconspicuous area.
    • Vacuum up any loose dirt and debris.
    • Apply Vital Oxide that’s been diluted 5 parts water to 1 part Vital Oxide at a rate of 1.7 gallons per 10 sq. yards (or approx. 22oz per sq. yd.). Because Vital Oxide must come in contact with contaminants in order to work, be sure to apply over the entire carpet area to be treated.
    • Allow Vital Oxide to remain on carpet for 10 minutes.
    • Do not rinse. Remove any excessive moisture by either blotting or wiping with a dry towel or use a water extraction wand.
    • Allow carpet to air dry or use blowers or fans if quicker drying is required.
  • For Fogging and Misting:

    • Apply Vital Oxide by Fogging and Misting until surface is is moist.
    • Remove or protect  all food and food packaging material prior to treatment.
    • Vacate the treatment area and do not reenter until the air is clear (minimun of 20 minutes)
    • Allow to air dry